“The use of wing / wing section aft (rear) at first only used on cars that will fight arena racing to increase tire traction, because the wing is believed to control the direction of the wind that came to the car so the car gets more press power on the stern (down force) order to keep moving smoothly over the asphalt without hovering or twist when cornering”

General form of wing has a fairly high pillar with a sheet of carbon that is designed large enough and the curve of a sporty little look stiff and heavy.

As they are used in racing, so it means any material used in the form of carbon because in addition to more powerful but also lighter than the model of a fast fiber made from broken or iron plates that are too heavy. In its development, it’s been a lot of wing only minor modifications to the use of accessories various kinds of cars.

The model is also there that have made the original such as wing factory add-on that is mostly made of carbon and some are custom models that are usually formed from fiber by a modifier for fashion purposes only.

To model the add-on installation does not require a long time because the goods have been available and for custom models require a rather long time about 3 days to a week, from manufacture to installation. Rates applied were varied, which is sure to wing made from carbon is more expensive than those made from fiber material.

For installation, the wings with the hood of the trunk should be given initially sealant used for precise position, and then fastened by nuts and bolts, so it must be hollowed-sized trunk diameter of the nut with precision so that no more holes that can enter the water.